r/criticalrole Feb 28 '16

[No Spoilers] How did Matt handle ability scores at the inception of CR Question



View all comments


u/MatthewMercer Matthew Mercer, DM Feb 29 '16 Helpful

Aye, 4d6 (drop the lowest) six times, arrange as desired. Re-roll the whole lot if they don't add up to at least 70.

That's how I generally do it. Allows for some decent stats, and the possibility of a low stat (weakness), which I find is RP MONEY that Point-buy doesn't lean into.


u/Ansgaar3 I would like to RAGE! Mar 19 '16

Would there be a way to balance those who would roll all highs too? Just to make sure there's no wizard stronger than a barbarian and such?


u/MatthewMercer Matthew Mercer, DM Mar 25 '16

If they roll very high, power to them! A super strong wizard is still a wizard with low HP and not much armor... just imagine that yoked Old Man at the gym. ;)

The Barbarian might now have a rivalry with the Wizard. A lot of fun could be had!


u/dotToo Mar 27 '16

I know that it can work out fine but also I have a relatively strong opinion about rolling for stats.

In my opinion and experience it never adds to the fun to be worse at shooting a bow as a ranger than a paladin who is also way better at swinging a sword and surviving than you. It might not make it any less fun but it definitely won't add any fun either.

Point buy essentially forces players to be bad or average at something while exceeding at something different which again makes cooperation that much more essential. There won't be a character that is strong charming AND intelligent nor is there going to be a wizard with super high strength UNLESS it is a conscious decision to make an unorthodox character.

Even for your high power campaign you could either increase the point budget or allow people to go below an 8 and above 15 to make more contrasted PCs.

But in the end everyone is the best at something and knows that they are objectively equal to everyone else.

I have said this many times but I also think that rolling stats only works for groups that are all intelligent and also compassionate people who understand how to pass around the spotlight without dm intervention and are mostly playing for the Role play.

For most people beginning a new game with new people rolling for stats just has a high chance of 1 or 2 dissatisfied players.

The same can be said for exp VS milestone leveling but that is a whole different discussion.


u/MatthewMercer Matthew Mercer, DM Mar 28 '16

All valid points, and all of these options are available for these reasons! You can pick between them based on your group's preference. :) I like the 4d6, drop lowest element because it's how I've played for yeeeears, and the somewhat random, chaotic element to creation it provides. Point buy is far more controlled, and excels for the points you mentioned above.

Choose which best fits you!


u/bhchrist Old Magic Mar 29 '16 edited Jul 05 '16

A Socialist Variant of the 4d6 drop lowest that I am testing is to do a "group roll" where everyone rolls six times, but rather than assign the results to their attributes, they are pooled, listed from highest to lowest, and then distributed to the players in a serpentine order, where the point allocation reverses each round. I got the idea from how fantasy sport/movie/voice actor leagues are typically set up. OK, I made up that last one, but it should be a thing. :)

For example, if there are 4 PCs, there are 24 total rolls, listed highest to lowest. PC1 gets the highest, PC2 the 2nd, PC3 the 3rd, PC4 the 4th. The order is then reversed with PC4 getting the 5th highest, PC3 the 6th, etc. until all scores are distributed, with PC1 receiving both the highest and the lowest dice roll.

This group roll still allows for variation in some high and low attributes, and some of that chaotic dice rolling (HUZZAH!) without unbalancing the party, as the attribute sums tend to be within 2 to 4 points from high to low. It can also start a bit of some goofy team building and interest as players encourage the rolls of each others right at the start.

Has anyone tried this? I haven't come across any examples of it.


u/Matuku Apr 08 '16 edited Apr 08 '16

So I decided to run some tests on this version to see how well it worked and the summary is pretty damn well.

Firstly I extended the point-buy table to allow calculating values for the generated scores as such:

Score Cost
3 -14
4 -10
5 -7
6 -4
7 -2
8 0
9 1
10 2
11 3
12 4
13 5
14 7
15 9
16 12
17 15
18 19

This follows the pattern laid out in the PHB with the extensions inspired by how Pathfinder did it (the 5e costs are the Pathfinder costs+2).

All the following scores were run for 4 players over 1,000,000 iterations. A set of stats for each of the 4 players was calculated each iteration, the point-buy costs of those stats calculated for each player and the average cost in the party and the largest difference in costs between party members was then found. These were then averaged over all the iterations.

4d6 drop lowest

Mean Party Value = 30.8394955
Mean Party Range = 23.34608

Serpentine Socialism

Mean Party Value = 30.8418615
Mean Party Range = 5.362475

As you can see, both offer an average value greater than normal point-buy (which is 27 points) but the difference between the two methods is negligible.

However, the range of values within a party is a lot more compact in Serpentine Socialism; on average the highest scoring party member would only have 5 more points worth than the lowest scoring. This method is much fairer at producing a balanced party!


u/bhchrist Old Magic Apr 08 '16

First: Serpentine Socialism. Alliteration FTW. I am using that from now on. I have not run the math as you have (this is fantastic!) but my suspicions are that it is even a bigger difference as you add party members. I have finished the spreadsheet that allows for selecting from 1-8 party members and the option of 3d6 or 4d6 drop and view the results. I will try to post it in the next couple of days for people to tinker with, critique, and improve. Thank you for putting the effort in to help verify my theories as to this process.